American Standard Hot Tub 2083 SERIES User Manual

2083 SERIES  
BATHING POOL  
STANDARD®  
HIGH GLOSS ACRYLIC  
SHOWN LESS ALL FITTINGS  
INSTALLATION INSTRUCTIONS  
60"  
(1524mm)  
7-3/4"  
(197mm)  
70mm  
(2-3/4)  
3/4"  
(19mm)  
FINISHED  
WALL  
THANK YOU...  
for selecting an American Standard bath. Your  
new bath is shipped to you after careful  
inspection. All you need to finish the installation  
are your selected fittings.  
4"  
15-3/8"  
(391mm)  
(102mm)  
229mm x 305mm  
(9 x 12)  
FLOOR  
CUTOUT  
4"  
(102mm)  
32"  
(813mm)  
To insure maximum performance and pleasure  
from this product, please follow the instructions  
and cautions.  
+
2-3/8" 13mm  
+
(2-3/8) (1/2)  
25mm  
(1)  
4-1/2"  
(114mm)  
C/L OF 1/2  
SUPPLIES  
AS REQ'D  
C/L OF  
DRAIN  
SHOWER ARM- 1/2 N.P.T.  
1-1/4"(32mm) DIA. HOLE  
List of Optional Components (not included):  
• Standard Bath Caddie 9533.100*  
C/L OF CURTAIN ROD  
USUALLY 76"(1930mm) FROM  
FINISHED FLOOR  
* see your American Standard Distributor  
FINISHED  
WALL  
4"  
C/L OF  
VALVES  
(2) 2-1/8"(54mm)  
DIA. HOLES  
(102mm)  
List of Required Components (not included):  
• Standard Bath Drain 1501.170*  
• Bath Filler*  
OPTIONAL  
TO FLOOR  
USUALLY  
BETWEEN  
65 & 78  
4"  
4"  
SPOUT-  
1/2 N.P.T.  
3-1/2"  
(89mm)  
(102mm)  
(102mm)  
16"  
(406mm16)  
(1651 & 1981mm)  
1"  
* see your American Standard Distributor  
(25mm)  
SEE  
NOTE  
19-3/4"  
(502mm)  
20"  
(508mm)  
TOP OF DECK  
2"  
(51mm)  
ROUGH  
FLOOR  
4-5/8"  
(117mm)  
1-1/2 N.P.T. THREADS  
1-1/2 O.D. TAILPIECE  
List of Required Tools and Supplies:  
BATH SUPPORT MATERIAL  
Tools  
Supplies  
• Nails  
• Putty  
• Caulk  
• Level  
GENERAL SPECIFICATIONS FOR 2083 BATHING POOL  
INSTALLED SIZE  
Tape Measure  
• Pipe Wrench  
• Slip Joint Pliers  
• Screw Driver  
• Standard  
60 x 32 x 20 In.  
(1524 x 813 x 508mm)  
100 Lbs. (45 Kg.)  
(waterproof)  
WEIGHT  
• 1 x 3 or 2 x 4  
Stringers  
• Drop Cloth  
• Mortar Mix  
or Grout  
551 Lbs. (250 Kg.)  
WEIGHT w/WATER  
54 Gal. (204 L)  
GAL. TO OVERFLOW  
BATHING WELL AT SUMP  
BATHING WELL AT RIM  
WATER DEPTH TO OVERFLOW  
FLOOR LOADING  
18 x 42 In. (457 x 1067mm)  
25 X 54 In. (635 x 1372mm)  
14 In. (356mm)  
Woodworking Tools  
• Personal Safety  
Equipment  
41 Lbs./Sq.Ft. (202 Kgs./Sq.m)  
• Caulking Gun  
(PROJECTED AREA)  
20.8  
35.3  
PTS.  
3
CUBE (FT  
)
GENERAL INSTALLATION INFORMATION  
BATH MAY ONLY BE INSTALLED IN A RECESS TYPE INSTALLATION.  
Locate studs as required. Insure rough dimensions are proper, plumb, and square. The following procedure must be used for all  
installations: Leveling support stringer should be as indicated. This bath is not self-supporting and must be supported along it's entire  
bottom. Support with mortar or grout.  
Position bathtub within the recess, check level front to back and side to side, shim as necessary. To secure the tub to wood studs, use  
drywall screws with flatwashers or roofing nails immediately above the flange of the bath. To secure the tub to steel studs, use 4" drywall  
screws and flatwashers.  
SEE PAGE 2 FOR COMPLETE INSTALLATION INFORMATION.  
CAUTION: TAKE EXTRA CARE WHEN DRIVING NAILS OR SCREWS TO AVOID DAMAGING THE BATH.  
The tile or similar finished floor will be butted against the bottom of the tub apron, also holding the tub in place.  
FOR AFTER-SALES SERVICE CALL 1 (800) 442-1902 WEEKDAYS.  
© AS America, Inc. 2008  
All product names listed herein are trademarks  
of AS America, Inc. unless otherwise noted.  
753450-100 REV. B  
 

3Com Switch 2000 TR User Manual
3Com Telephone NBX User Manual
Aastra Telecom Telephone M5008 User Manual
Aiphone Video Gaming Accessories NH 50AC User Manual
Aiwa CD Player ADC EXI06 User Manual
AKG Acoustics Headphones K490NC User Manual
Alto Shaam Refrigerator mobile refigerated cart double comopartment User Manual
American Standard Hot Tub 2394 User Manual
Asus Network Card PR DLSR533 User Manual
Bacharach Carbon Monoxide Alarm True Spot User Manual