Advantek Networks Stereo System AWN 11N RT User Manual

Wireless - N  
Broadband Router  
Quick Installation Guide  
Model # AWN-11N-RT  
 
Back Panel Connectors  
Button/Port  
Description  
Reset  
Reset configurations to default. You would use the reset button only when  
a program error has caused your 11n AP router to hang. Press the button  
and hold for 10 seconds.  
WPS  
Click WPS button about 2-3 seconds while you are connecting a PC of  
wireless adapter with WPS function (you must enable WPS’ PBC  
function).  
LAN  
(1x, 2x, 3x, 4x)  
WAN  
Ethernet RJ-45 connector, connect to PC with a RJ-45 Ethernet cable.  
Ethernet RJ-45 connector, connect to WAN access device, such as the  
Cable modem or ADSL modem.  
PWR  
Power connector, connect to the power adapter packaged with the AP  
router.  
1.4 Installation Instruction  
1) Power off 802.11n AP Router and DSL/Cable modem.  
2) Connect computer to the LAN port on the Wireless Router with Ethernet cable.  
3) Connect the DSL or Cable modem to the WAN port on the Wireless Router with  
Ethernet cable.  
4) Power on DSL or Cable modem first, then connect power adapter to the power jack on  
the rear panel of Wireless Router and plug the power cable into an outlet.  
5) Check LEDs.  
a) Once power on Wireless Router, Power LED should be on.  
b) LAN LED should be on for each active LAN connection.  
c) The WAN LED should be on when the DSL or cable modem is connected.  
Warning: Only use the power adapter is provided from this package, use other power  
adapter may cause hardware damage  
2
 

Aastra Telecom Telephone 1600IP User Manual
Abocom Network Router WR104 User Manual
Accusplit Fitness Electronics 1590 User Manual
Acer Laptop ZY7 User Manual
Adaptec Network Card 29320A User Manual
a d s Speaker C10ps User Manual
AG Neovo Indoor Furnishings WMK 01 User Manual
Aiphone Security Camera JKW IP User Manual
AO Smith Water Heater LB 500 User Manual
Audiovox Remote Starter APS 55TW User Manual